Experimental and Numerical Studies of Multi-compartment Spreading Fire in a Full-Scale Steel Framed Building

Fire Technology - Fire dynamic characteristics in multi-compartments are still not very clear. This paper presents a spreading fire test in a full-scale two-storey steel framed building to...     

Hydrodynamics study of a fast liquid–liquid oxidation process with in situ gas production in microreactors

Hydrodynamics characteristics of a fast and highly exothermic liquid–liquid oxidation process with in situ gas production in microreactors were studied using a newly developed experimental method. In the adipic acid synthesis through the K/A oil (the mixture of cyclohexanol and cyclohexanone) oxidation with nitric acid, bubble generation modes were divided into four categories. The gas production became more intensive, unstable, even explosive with increasing the oil phase feed rate and the temperature. A novel automatic image processing method was developed to monitor the instantaneous velocity online by tracking the gas–liquid interface. The axial velocity at the same location was unstable due to the changing gas production rate. Furthermore, the actual residence time was obtained easily with being only 36% of the space–time minimally, beneficial for establishing accurate kinetics and mass transfer models with time participation. Finally, an empirical correlation was developed to predict the actual residence time under different conditions.     

Modulation of electrical transport in calcium cobaltite ceramics and thick films through microstructure control and doping

Ca₃Co₄O₉ is a promising p-type thermoelectric oxide material having intrinsically low thermal conductivity. With low cost and opportunities for automatic large scale production, thick film technologies offer considerable potential for a new generation of micro-sized thermoelectric coolers or generators. Here, based on the chemical composition optimized by traditional solid state reaction for bulk samples, we present a viable approach to modulating the electrical transport properties of screen-printed calcium cobaltite thick films through control of the microstructural evolution by optimized heat-treatment. XRD and TEM analysis confirmed the formation of high-quality calcium cobaltite grains. By creating 2.0 at% cobalt deficiency in Ca_2.7Bi_0.3Co₄O_9+δ, the pressureless sintered ceramics reached the highest power factor of 98.0 μWm^?1 K^-2 at 823 K, through enhancement of electrical conductivity by reduction of poorly conducting secondary phases. Subsequently, textured thick films of Ca_2.7Bi_0.3Co_3.92O_9+δ were efficiently tailored by controlling the sintering temperature and holding time. Optimized Ca_2.7Bi_0.3Co_3.92O_9+δ thick films sintered at 1203 K for 8 h exhibited the maximum power factor of 55.5 μWm^?1 K^-2 at 673 K through microstructure control.     

Spectral radiance reconstruction from trichromatic camera responses based on orthogonal test and regularized algorithm

Reconstruction of spectral information based on multi‐channel image system is a significant problem in color reproduction, detection, and recognition. A spectral radiance reconstruction from trichromatic digital camera responses is researched in this article. The mapping relationship between the trichromatic imaging system response and the incident spectral radiance is analyzed. Then, in order to remove the ill‐posedness of the problem, a regularized constraint solution model of spectral radiance reconstruction matrix is established. And the spectral radiance can be reconstructed by spectral radiance reconstruction matrices and trichromatic imaging system response. Finally, the spectral radiance reconstruction matrix is estimated by the system radiometric calibration experiment. The input radiance is offered by a LCD display. A 3‐factor and 9‐level orthogonal test is designed for the calibration experiment, and a test set of 24 colors is used for precision analysis. The results show that the average relative mean error of our method is 8.69%, it is lower than that of Wiener filtering method by 2.84%. The method can reconstruct spectral radiance information effectively.     

脉冲高度权重技术测量197Au中子俘获截面

脉冲高度权重技术是利用C_6D_6探测器测量中子俘获截面的一种数据处理方法。在中国散裂中子源(China Spallation Neutron Source,CSNS)的反角白光中子源(Back-n)靶站上,通过测量金靶(~(197)Au)的中子俘获截面,验证了该方法的可靠性。首先利用Geant4蒙特卡罗程序模拟给出了不同靶条件下的探测器效率,脉冲高度权重函数等基本项,使得加权后的探测器效率与γ能量成正比。然后通过实验测量了~(197)Au中子俘获截面。结果表明:测量获得的中子俘获截面数据和ENDF/B-VⅢ.0评价数据相符合,同时发现随着实验靶尺寸的不同和质子束功率的增加,会使得实验本底的扣除误差越来越大。     

In-situ synthesis of zirconium oxycarbide by electroreduction of ZrO2/C in molten salt

Homogenous ZrC_xO_y powders have been successfully synthesized by in-situ electro-reduction of solid ZrO₂–C composite precursors in molten CaCl₂. The effect of applied cell voltage and molar ratio of ZrO₂ to C on preparation of ZrC_xO_y were investigated. The reduction pathway of the composite electrode was studied based on the analysis of intermediate products using X-ray diffraction (XRD) and scanning electron microscopy (SEM). The results show that ZrO₂ is firstly converted to CaZrO₃. The resulting CaZrO₃ is then reduced to ZrC_xO_y. The ZrC_xO_y formation is dramatically influenced by electrolysis voltage and molar ratio of ZrO₂ to C: a higher cell voltage and lower molar ratio of the ZrO₂ to C are more preferable for the formation of ZrC_xO_y powder. Homogenous ZrC_xO_y powders with particle size of ~100 nm are synthesized by ZrO₂/C starting elemental powders in CaCl₂ molten salt at 1123 K for more than 3 h, when the cell voltage is 3.0 V and the molar ratio of the ZrO₂ to carbon starting materials is 1:1.0.     

基于回归分析的玉米膜下滴灌适宜土壤含水量及阈值研究

为确定半干旱地区膜下滴灌条件下玉米生长与土壤含水量间的关系,利用通榆灌溉试验站2018年度玉米膜下滴灌灌溉制度试验数据,分析不同灌溉制度下的玉米产量,并对不同灌溉制度下的玉米株高、茎粗、叶面积等指标进行回归求解,得到了玉米各生育阶段的适宜土壤含水量及其阈值.玉米膜下滴灌各生育阶段的适宜土壤含水量区间:苗期65％—75％、拔节期70％—80％、抽雄吐丝期75％—85％、灌浆期75％—85％、乳熟期70％—80％;水分胁迫阈值:苗期50％、拔节期57％、抽雄吐丝期66％、灌浆期60％、乳熟期58％.     

Study on element detection and its correction in iron ore concentrate based on a prompt gamma-neutron activation analysis system

A prompt gamma-neutron activation analysis(PGNAA) system was developed to detect the iron content of iron ore concentrate. Because of the self-absorption effect of gamma-rays and neutrons, and the interference of chlorine in the neutron field, the linear relationship between the iron analytical coefficient and total iron content was poor, increasing the error in the quantitative analysis. To solve this problem, gamma-ray self-absorption compensation and a neutron field correction algorithm were proposed, and the experimental results have been corrected using this algorithm. The results show that the linear relationship between the iron analytical coefficient and total iron content was considerably improved after the correction. The linear correlation coefficients reached 0.99 or more.